GATE NanoHARD Multifunction AEG Mosfet

NanoHARD is multifunction programmable AEG Controller.

It has 8 functions:

ON/OFF Active Brake
This is the first controller that provides you with possibility to turn off Active Brake. You can enable or disable the Active Brake at any time.

Battery protection
Protection against Over-Discharge of Battery. Modern LiPoly batteries are very sensitive to over-discharge. If you do not want to damage the battery and you care about its service life, this protection is indispensable. Microprocessor will constantly watch over the battery voltage. When it drops down to critical value, it will not permit to make a shoot. It supports: Li-Po 7.4V / 11.1V / 14.8V. You can also disable the protection and use other batteries.

Smart fuse
The new AEG Controller will never let you down on the battlefield. It is the best electronic fuse that has ever been made. This is the first AEG Controller with true current sensor. Combination of current, voltage and temperature measurements provides your AEG installation with the highest reliability. If your rifle becomes jammed, it protects motor and battery against any damage. There is no way to destroy the Controller by overheating, overload or short-circuits of the electrical system.

Build-In Self-Test
It allows you to quickly check whether the AEG Controller works properly. If you have problems with your AEG, the BUILT-IN SELF-TEST allows you to easily exclude that the problem is caused by the controller.

Debouncing
This provides full compatibility with the micro-switches. It ensures full resistance to contact bounce (vibration). You gain a bigger ROF, a faster trigger response and your MOSFET is less prone to overheating.

3rd Gen Mosfet
The advent of modern transistors and microcontroller has enabled us to create the smallest and most reliable AEG Controller on the market.

14.8V Li-Po Ready
The system can be used with batteries up to 14.8V LI-PO. Minimum operating voltage is 3V and maximum voltage is 17V.

Coating
Thanks to its special conformal coating, it is resistant to atmospheric conditions (Military Specification MIL-V-173C).

Active Brake
Do you care about realism? Would you like to increase the life of the gearbox? Does your rifle have such a high rate of fire that you are not able to make a single shot? The Active Brake sorts things out. In SEMI Mode, the brake does not allow for compressing a piston after a shot. The piston will stop in the front position which eliminates unnecessary stresses, increasing the service life of the gearbox and its parts. This is important, especially with an AEG power upgrade. After releasing the trigger, the rifle immediately stops firing. So, you gain more realism and, additionally, you do not waste your precious ammunition.